LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S6 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Controls, Housing 0CJ, 0CK, 0HL, 0DN, 0DP)) >> 34 Controls, Housing >> ATF Circuit >> ATF Cooler, Removing And Installing >> Installing

ATF Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

NOTE:

Replace the ATF line with seals after removing.

Clean the ATF cooler before installing.

CAUTION:

ATF cooler leak!

  • Pay attention to the ATF pipe installation position.
  • The side of the pipe with three seals faces the ATF cooler.

-- Install the bolts all the way in by hand and tighten in the previously specified tightening sequence.

-- Fill the ATF. Refer to ATF, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals