Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine and Gearbox Bracket:VAS 6095A

Fig 1: Engine And Transmission Holder
Courtesy of AUDI OF AMERICA, LLC

Procedure

Engine engaged with the Engine Sling:2024A on the Shop Crane:VAS 6100 . Refer to ENGINE, REMOVING FROM SCISSOR LIFT TABLE .

-- Remove the intermediate plate. Refer to Fig 2.

Fig 2: Installing Intermediate Plate

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left alignment sleeve from the cylinder block.

-- Secure the engine to the Engine and Gearbox Bracket:VAS 6095A -item 1-.

Courtesy of AUDI OF AMERICA, LLC

Assembling

Assemble in the reverse order of removal. Note the following:

-- Insert the left alignment sleeve into the cylinder block.

-- Install the intermediate plate. Refer to Fig 2.

Fig 3: Installing Intermediate Plate

Courtesy of AUDI OF AMERICA, LLC