Assembly Mount Sensor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Assembly Mount Sensor 1 -G748- (left):

-- Remove the noise insulation (front). Refer to OVERVIEW - NOISE INSULATION .

Assembly Mount Sensor 2 -G749- (right):

-- Audi A8: Remove the right subframe shield upper section. Refer to appropriate Service Information .

-- Remove the right drive axle heat shield. Refer to appropriate Service Information .

Continuation for Both Sides:

Fig 1: Assembly Mounts Sensor Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and remove the assembly mount sensor (example image).

TIP:

Bolt is accessible from above.

-- Disconnect the connector -1-.