Coolant Pump Toothed Belt, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
- Note the toothed belt sprocket installation location ) OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT.
- Used coolant cannot be used again.
-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .
Refer to the appropriate service information
-- Connect the coolant hose to the connector coupling. Refer to Figure.
-- Fill the cooling system. Refer to COOLANT, FILLING USING Cooling System Charge Kit:VAS 6096 [DMTA, DPAA, DPUA, DPVA, DMTC, DRYA, DUVA] .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .