Right Flange Shaft, Removing And Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Circlip Pliers :VAS 5503A

Courtesy of AUDI OF AMERICA, LLC
Used Oil Collection and Extraction Unit :SMN372500

Fig 1: Identifying Used Oil Collection And Extraction Unit
Courtesy of AUDI OF AMERICA, LLC
Puller - Flanged Shaft :T10037

Fig 2: Identifying Flanged Shaft
Courtesy of AUDI OF AMERICA, LLC
Adapter :T10037/2

Courtesy of AUDI OF AMERICA, LLC
Sealing Grease. Refer to the Parts Information.

Removing

The transmission is installed.

-- Remove the right drive axle. Refer to DRIVESHAFT .

-- Remove the right drive axle heat shield. Refer to the appropriate service information .

-- Place the Used Oil Collection and Extraction Unit :SMN372500 under the transmission.

-- Remove right flange shaft by fastening Puller - Flanged Shaft :T10037 to transmission housing -arrow-.

Fig 3: Identifying Right Flange Shaft By Fastening T10037

Courtesy of AUDI OF AMERICA, LLC

-- Use the Adapter :T10037/2 , if necessary.