Transmission Mount, Removing And Installing, Automatic Transmission
Transmission Support, Removing with Transmission Mount
-- Remove the tunnel crossmember. Refer to appropriate Service Information .
-- Remove the bolts -arrows- and remove the transmission support -1- with the transmission mount from the transmission.
Transmission Mount, Removing
-- Remove the bolts -1- and remove the stop -2- for the transmission mount.
-- Remove the nut -5- and remove the transmission mount -3- from the transmission support -4-. (The transmission support does not correspond to the version in the vehicle.)
Installing
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the nut -5- hand-tight.
-- Tighten the bolts -1- and then the nut -5-.
Tightening Specifications
- Refer to appropriate Service Information .