Left Engine Mount, Removing And Installing, 3.0L Engine: Removing
- Install all the cable ties back in their original locations.
-- Support the engine in the installation position (refer to ENGINE, SUPPORTING IN INSTALLATION POSITION ) and pretension it with the Engine Support Set - Spindle:10-222B/11 until the pressure on the engine mount is released.
-- Remove the front wheel. Refer to WHEELS AND TIRES .
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the front wheel spoiler, and loosen the front of the wheel housing liner and press it to the side. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Remove the bolts -arrows- and push the left coolant pipe to the side.
-- Remove the ribbed belt from the A/C compressor belt pulley. Refer to RIBBED BELT, REMOVING AND INSTALLING .
-- Remove the A/C compressor from the bracket and tie it up on the left side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING ON BRACKET .
-- Disconnect the connector -arrow- for the electrohydraulic engine mount solenoid valves.
-- Remove the bolts -arrows- and engine mount -1-.