Ribbed Belt For Generator, Removing And Installing, 2.9L Engine: Installing

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

-- Pivot the ribbed belt tensioner for the generator using a wrench slightly counter-clockwise -arrow- and remove the Locking Pin:T10060A  .

-- To tension the ribbed belt release the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Install the A/C compressor ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Start the engine and check the ribbed belt routing.

There are different procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .