Oil Pan Lower Section, Removing And Installing: Removing

• Engine oil drained. Refer to ENGINE OIL .

-- If installed, remove the bolt -1- and push the bracket -2- with the wiring harness to the side.

Fig 1: Identifying Wiring Harness Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -arrow- from the Oil Level Thermal Sensor -G266-.

Fig 2: Oil Pan Lower Section - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wires.

-- Loosen and remove the bolts in the following sequence: -17 to 1-.

-- Loosen and remove the oil pan lower section carefully from the bonding.