All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING, 0D3 AND 0BX: Notes

Special tools and workshop equipment required 

• Hex Ball Socket:T10058 
  Fig 1: Hex Ball Socket T10058

  Courtesy of AUDI OF AMERICA, LLC

• Pay attention to the general repair information. Refer to REPAIR INFORMATION .
• Pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS .

Removing 

-- Place the vehicle on a hoist.

• The ignition is off.

-- Place the Drip Tray under the rear final drive.

-- Disconnect the connector -1- from the All-Wheel Drive Pump -V415- -2-.

Fig 2: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the four bolts that connect the All-Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket:T10058  .

-- Carefully remove the All-Wheel Drive Pump -V415- -2-. Pay attention to the adapter  ) OVERVIEW - HYDRAULIC CONTROL UNIT 0D3 AND 0BX in the hydraulic pump while doing so.

• The adapter could fall out when removing the All-Wheel Drive Pump -V415-.
• Insert the adapter into the recesses in the hydraulic pump before installing the All-Wheel Drive Pump -V415-.