Front Sunroof Shade, Removing And Installing, A6: Removing
-- Remove the glass panel. Refer to FRONT GLASS PANEL, REMOVING AND INSTALLING, A6 .
-- Guide the sunroof shade all the way toward the rear -2-.
-- Then guide the sunroof shade forward to dimension -a- back into -1-.
- Dimension -a- = approximately 70 mm
-- Press down carefully to release the retainer -1- and move the bow -2- to the side -arrow A- until the bow is pulled out of the carrier on the other side.
-- Lift the bow -1- in direction of -arrow A- and slide it in the direction of -arrow B- until it releases from the carrier on the opposite side.
-- Guide the sunroof shade material -2- forward from under the carrier -3-.
-- Place the sunroof shade toward the front.
-- Remove the bolts -6 and 8-.
There is a risk of damage due to improper handling.
- Be very careful when pressing on the lever in the center of the carrier.
-- In the center of the carrier -4-, push on the lever -2- in direction of -arrow- and at the same time, remove the gear carrier -7- toward the rear out of the sunroof shade frame -5- while the slider -3- is pulled forward.
-- Repeat the procedure on the opposite side.
-- Remove the sunroof shade -1-.