Luggage Compartment Cover Drive Unit, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Clip both catches -2- for the luggage compartment cover into the rails and secure with an expander pin -1-.
-- Perform a function test after installing.
Conditions
- Both of the carriers must be parallel to each other at the top and bottom of the stop in the D-pillar trim panel guide.
- If the catches are not parallel, check the routing of the release cable and/or adjust the release cables.
Adjusting the release cables for the drive unit
-- Adjust the release cable at the release cable adjuster -1-.
-- Turn the release cable adjuster in the direction of -arrow A- or -arrow B-.
-- Adjust the release cable so that both of the luggage compartment cover catches are parallel to each other.
Continuation