Rear Lid Lower Trim Panel, Removing And Installing, A6 Sedan: Removing
-- Unclip the rear lid latch trim panel -1- using the Removal Wedge :T40233 in the -direction of the arrow-.
-- Open the cover and remove the emergency triangle from the bracket to do so press the catch.
-- Release the retaining tabs -arrows- and remove the emergency triangle bracket -1-.
-- Unclip the stop strip -1- using the Trim Removal Wedge :3409 -arrow-.
-- Repeat the procedure on the opposite side.
-- To remove the expanding clips -1-, push the clamping pin -2- in approximately 5 mm until it engages audibly in the expanding clip -arrow- (do not push in completely, otherwise the clamping pin will be lost).
-- Remove the released expanding clip with a clamping pin.
-- Pull the rear lid hinge trim panel -3- downward out of the rear lid trim panel and remove it.
-- Repeat the procedure on the opposite side.
-- If installed, remove the screw -1-.
-- If installed, remove the rear lid closing button. Refer to REAR LID CONTROL HEAD EX58, REMOVING AND INSTALLING .
-- Unclip the rear lid trim panel -1- starting at the top of the rear lid -A arrows- using the Pry Lever :80 - 200 .
-- Unclip the side of the rear lid trim panel -1- from the rear lid -B arrows-.
-- Unclip the lower rear lid trim panel -1- from the rear lid -C arrows- and remove.