Center Rear Three-Point Seat Belt, Removing And Installing, A6 Sedan: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the front seats all the way forward.
-- Remove the fixed backrest or the individual rear seat backrest. Refer to .
-- Remove the center rear belt end fitting. Refer to .
-- Remove the D-pillar trim panels. Refer to D-Pillar Trim Panel, Removing and Installing .
-- Remove the C-pillar trim panels. Refer to C-Pillar Trim Panel, Removing and Installing .
-- Remove the rear shelf. Refer to Rear Shelf, Removing and Installing .
-- Loosen the bolt -1- (luggage compartment side) approximately seven turns.
-- Push the rear shelf noise insulation to the side in the area of the seat belt.
-- Push the three-point seat belt -2- toward the rear out of the mount and remove upward -arrow-.