Front Belt End Fitting, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seat all the way to the front and into the highest position.

-- Remove the B-pillar lower trim panel. Refer to B-Pillar Lower Trim Panel, Removing and Installing .

Belt end fitting without seat belt tensioner

-- Push the carpet in the threaded connection area to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-.

-- Remove the bolt with the belt anchor -2-.

Continuation for all vehicles

Belt end fitting with seat belt tensioner

-- Push the carpet in the belt end fitting -3- area to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and then remove the belt relay -2-.

-- Disengage the belt end fitting -3- from the bracket.

-- Open the cover -2- for the belt anchor -1- on the catches -arrow-, open and push aside.

Courtesy of AUDI OF AMERICA, LLC

-- Push together the catches on the clamp with pliers -A arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- At the same time push the anchoring pins -2- together with the clamp -3- to release in the -direction of arrow B-.

-- Disengage the anchoring pin -2- from the clamp -3- in the belt end fitting -1-.

Continuation for all vehicles