Wiper Arm, Adjusting
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Procedure
-- Remove the windshield wiper arm. Refer to Windshield Wiper Arm, Removing and Installing .
-- Switch the ignition on.
-- Activate "rear wiping" and let the wiper arm run to end position.
-- Switch off the ignition.
-- Position the wiper arm -1- with wiper blade installed at the wiper axle.
-- Align the wiper blade tip to the rear window lower edge.
Conditions
- Dimension -a- = 19 + 5 mm.
-- Tighten the wiper arm nut.
-- Switch the ignition on.
-- Activate "rear wiping" and let the wiper arm run to end position.
-- Check the wiper arm adjustment again and correct if necessary.
Tightening Specifications
- Refer to Overview - Rear Window Wiper System .