Part II
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
Part III. Refer to Part III .
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4- Part II => List Item:Stud Bolt
- Tensioning Bracket
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 15- Part II => List Item:Nut
- Tensioning Bracket
- Nut
- 30 Nm
- After loosening, replace the stud bolt -item 4- Part II => List Item:Stud Bolt
- Oil Return Line
- Replace after removing
- Clip
- Air Duct Pipe
- Bolt
- Tightening specification -item 9- OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE VERSION 1 => List Item:Bolt.
- Seal
- Replace after removing
- Air Duct Pipe/Connections
- There are different versions. Refer to the Parts Information for the allocation.
- Bolt
- Tightening specification -item 12- OVERVIEW - CHARGE AIR SYSTEM, 3.0L ENGINE-SIDE VERSION 1 => List Item:Bolt.
- Seal
- Replace after removing
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Turbocharger
- Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
- Screw-Type Clamp
- 20 Nm
- Replace after removing
- Seal
- Replace after removing
- Coupling
- If a new turbocharger is installed, replace the coupling
- Nut
- Replace after removing
- Tightening Specifications:
- Step 1: 15 Nm
- Step 2: 30 Nm
- Step 3: After finishing the procedures, tighten the nuts to 30 Nm
- Seal
- Replace after removing
- Stud Bolt
- 15 Nm
- After loosening, replace the nut -item 20- Part II => List Item:Nut