ADDITIONAL WORK AFTER REPLACING FINAL DRIVE 0D3 "quattro sport" AND 0BX "quattro sport"
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- If the rear final drive was replaced, the following additional work is necessary.
- Bleed the hydraulic control module using the Vehicle Diagnostic Tester .
- Program the rear final drive to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester .
- The additional work can only be performed when the rear final drive is replaced.
Procedure :
-- Connect the Vehicle Diagnostic Tester and turn on the ignition.
-- Select the function 32 - Rear Final Drive Replacing on the Vehicle Diagnostic Tester under Guided Functions in the directory 32- Locking Electronics .
- Follow all the instructions given by the Vehicle Diagnostic Tester exactly.
The new rear final drive is "adapted" to the Differential Lock Control Module -J187- using the Vehicle Diagnostic Tester.
- A system check will take place when the function 32 - Rear Final Drive Replacing is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.