Coil Springs: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Compress new spring with spring compressor:VAG1752/1 and spring holders :VAG1752/5 .

Courtesy of AUDI OF AMERICA, LLC

Note color coding (arrow)

-- Pull shock absorber shaft out of shock absorber to stop.

Courtesy of AUDI OF AMERICA, LLC

-- Install coil spring along with spring compressor onto lower spring retainer.

Color coding on spring faces toward lower spring retainer.
End of spring coil rests against spring retainer stop.

-- Install upper spring retainer with washer on coil spring so that end of spring coil rests against stop on washer.

-- Install washer on shock absorber shaft.

-- Install shock absorber shaft nut and tighten using with torque wrench and special tool :3078 .

Courtesy of AUDI OF AMERICA, LLC

Tightening torque: 60 Nm (44 ft lb)

-- Release tension on spring.

-- Remove spring compressor.

-- Install boot in upper spring retainer.