Fig. 6 Installing extractor in rear subframe bushing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of AUDI OF AMERICA, LLC
|
-- Remove mounting bolt for subframe assembly.
-- Install puller (e.g. Kukko No. 21/2).
-- Tighten nut (arrow) until two jaws of puller spread in bushing. To counterhold, place suitable screwdriver through hole in puller.