Anti-Theft Alarm System Sensor G578, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
If the Anti-Theft Alarm System Sensor -G578- is replaced, perform the test plan for replacing the control module.
-- Perform the "control module, replacing" function using the => Vehicle Diagnostic Tester Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation
-- Remove the interior lamp frame. Refer to INTERIOR LAMP FRAME, REMOVING AND INSTALLING .
-- Release the retainers -arrows-.
-- Remove the anti-theft alarm system sensor -3-.
-- Release the retainers -1- and -5-.
-- Release the individual sensors -2-, -4- and -6- for interior monitoring from the interior lamp/reading lamp.
-- Free up the wires.
-- Remove the anti-theft alarm system sensor.