Headlamp Housing, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check all adjusting mechanisms -2- at the headlamp.
Conditions
- The adjusting nut -1- must be able to turn easily -arrows-.
-- Rotate the adjusting nut all the way down but do not tighten it.
-- Align the headlamp with the fender edge.
Conditions
- The headlamp must be flush with the fender.
Tip
Tightening the bolt automatically turns the adjusting nut on the adjuster against the headlamp housing mounting point and secures the housing.
-- Refer to HEADLAMP, ADJUSTING, LED HEADLAMP / HEADLAMP, ADJUSTING, MATRIX LED HEADLAMPS .