Access/Start System Antenna In Luggage Compartment R137, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles without high-voltage system (0K0/0K4)

-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .

-- Press the spare tire well trim to the side in the area near the antenna.

Tip

If the access/start authorization system antenna in the luggage compartment cannot be removed as described, the spare tire well trim must be removed. Refer to SPARE TIRE WELL TRIM, REMOVING AND INSTALLING .

Continuation for all vehicles

Vehicles with high-voltage system (0K3)

-- Remove the luggage compartment floor. Refer to LUGGAGE COMPARTMENT FLOOR, REMOVING AND INSTALLING, VEHICLES WITHOUT HIGH-VOLTAGE SYSTEM .

-- Remove the structural foam from the left side of the Battery -A-.

Continuation for all vehicles

-- Remove the nuts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Access/Start System Antenna In Luggage Compartment -R137- -1-.

-- Disconnect the connector -2-.