ATF Lines, Removing And Installing: Clean

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Before installing a replacement transmission, always clean out the ATF cooler and ATF lines using compressed air (maximum 10 bar (145.03 psi)).

-- Place the :SMN372500 under the transmission.

If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and lines using clean ATF.

Tightening Specifications

Refer to OVERVIEW - NOISE INSULATION .