ATF Cooler, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the noise insulation. Refer to apporpriate Repair Information .
-- Place the :SMN372500 under the transmission.
-- Disconnect the ATF lines -1 and 4-. Refer to Figure.
-- Place a clean cloth under the separating point to catch the escaping coolant.
-- Loosen the hose clamps -2 and 3- and then disconnect and remove the coolant hoses with :3094 .
-- Remove the bolts -arrows- and remove the ATF cooler.