Cover And Cushion, Removing And Installing, Rear Bench Seat: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Engage the rear molding into the seat frame first, and then pull the cover tight.
-- Flip the protective strip -1- over 180° toward the inside -arrow A-.
-- Engage the protective strip in the groove on the molded part -arrow B-.
- After installing, make sure the cover is free of folds.