Backrest Heating Element, Removing And Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The old heating elements remain on the cushion and will be covered over by the new heating elements.
Procedure
- Cover and cushion separated. Refer to COVER AND CUSHION, SEPARATING .
-- Align the new heating element -arrows- on the cushion.
-- Peel the protective film off the heating element one after the other. Be careful not to damage the heating element.
-- Glue the heating element so that it aligns with the old heating element and is not wrinkled.
-- Route the connecting wires to the individual heating elements in the base of the gaps.
TIP:
The Standard/Sport seat in leather is shown.
Further installation is performed in reverse order of the removal.