Diagnostic Entries
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Diagnostic entry with the Vehicle Diagnostic Tester.
- Turn on and connect the Vehicle Diagnostic Tester.
- Switch the ignition on.
- Select "Diagnostic" operating mode and "Start diagnostics".
- Select the "Test plan" tab.
- Select the "Individual tests" button, then, for the respective component/control module, select the following items in the tree structure one after the other:
Test programs by component/control module
- 1. J234 Airbag Control Module, Removing and Installing
- 2. J234 Airbag Control Module, Replacing
- 3. J706 Seat Occupant Detection System Control Module, Replacing
- 4. Reversible Seat Belt Tensioner, Replacing
1. J234 Airbag Control Module, Removing and Installing
- 0015 - Airbag Control Module - J234
- 0015 - Airbag, functions
- 0015 - Basic setting
- 0015 - Inertial sensors basic setting
2. J234 Airbag Control Module, Replacing
- 0015 - Airbag Control Module - J234
- 0015 - Airbag, functions
- 0015 - Airbag Control Module, Replacing
3. J706 Seat Occupant Detection System Control Module, Replacing
- 0015 - Airbag Control Module - J234
- 0015 - Airbag, functions
- 0015 - Basic setting
- J706 - Control module, seat occupant detection system, basic setting
4. Reversible Seat Belt Tensioner, Replacing
- 0015 - Airbag Control Module - J234
- 0015 - Airbag, functions
- 0015 - LIN Participant
- J234 - Seat Belt Tensioner Control Module, Basic Setting
- J234 - Left Seat Belt Tensioner Control Module, Output Diagnostic Test Mode
- J234 - Left Rear Seat Belt Tensioner Control Module, Output Diagnostic Test Mode
- J234 - Right Rear Seat Belt Tensioner Control Module, Output Diagnostic Test Mode