Plenum Chamber Bulkhead, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Remove the foam seal and remove any adhesive residue.

-- Clean the plenum chamber bulkhead with Cleaning Solution:D 009 401 04 .

-- Push on the new plenum chamber bulkhead seal and shorten if necessary. Refer to Parts Information.

Make sure the seal between the plenum chamber bulkhead and the body is seated correctly.

Vehicles with High-Voltage System:

CAUTION:

There is a risk of fatal injury due to high voltage.

Electrocution by direct contact or electric arc can cause severe bodily injury or fatal injury.

- Have an Audi high-voltage technician or an Audi high-voltage expert bring the high-voltage system back into service.

-- Re-energize the high-voltage system. Refer to appropriate Repair Information .

-- Fill the coolant and bleed the system. Refer to COOLANT, DRAINING AND FILLING .