Wheel Covers, Removing And Installing, Rear: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the door or the side panel is replaced it must be oriented to the door cover or the wheel arch trim on the opposite side.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution:D 009 401 04 and let dry.
-- Fold back the end of the protective film, or attach a pulling aid to the protective film.
-- Position the wheel arch trim -4- on the side panel -5- according to the mark made during the removal.
-- Remove the protective film on the pulling aids from the adhesive tape -7-.
-- Push on the wheel arch trim -4- with the Roller:T40400 .
- Resting time approximately 30 minutes at room temperature