Overview - Trim Molding
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Front Door Trim Molding
- Removing and Installing. Refer to TRIM MOLDING, REMOVING AND INSTALLING, FRONT DOOR .
- Tail Lamp Trim Molding
- Always replace after removing
- Right
- To remove, warm up carefully with the Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A .
- Tail Lamp Trim Molding
- Always replace after removing
- Center
- To remove, warm up carefully with the Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A .
- Tail Lamp Trim Molding
- Always replace after removing
- Left
- To remove, warm up carefully with the Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A .
- Side Window Trim Molding
- Only removable with the side window
- Side Window, Removing and Installing. Refer to REAR SIDE WINDOW, REMOVING AND INSTALLING .
- Rear Door Trim Molding
- Removing and Installing. Refer to TRIM MOLDING, REMOVING AND INSTALLING, REAR DOOR .