Overview - Output Shaft, Vehicles With Self-Locking Center Differential
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Internal Multi-Point Bolt
- Replace after removing
- 300 Nm
- Output Shaft Ball Bearing
- Bearing "H"
- Installation position: distance points to the drive wheel for spur gear unit OVERVIEW - OUTPUT SHAFT, VEHICLES WITH SELF-LOCKING CENTER DIFFERENTIAL => List Item:Spur Gear Unit Drive Wheel
- Removing. Refer to Figure.
- Installing. Refer to Figure.
- Spur Gear Unit Drive Wheel
- Installation position: groove from the drive wheel for spur gear unit points to the output shaft ball bearing OVERVIEW - OUTPUT SHAFT, VEHICLES WITH SELF-LOCKING CENTER DIFFERENTIAL => List Item:Output Shaft Ball Bearing
- Removing. Refer to Figure.
- Installing. Refer to Figure.
- Circlip
- Inner Output Shaft Roller Bearing
- Bearing Shell
- Inner Output Shaft
- Removing. Refer to Inner Output Shaft Roller Bearing, Removing, Vehicles with Self-Locking Center Differential .
- Installing. Refer to Fig 2.
- Disassembling and Assembling. Refer to INNER OUTPUT SHAFT, DISASSEMBLING AND ASSEMBLING, ONLY VEHICLES WITH SELF-LOCKING CENTER DIFFERENTIAL .
- Needle Bearing
- Bearing "31" and "33"
- Quantity: 2
- Circlip
- 4th Gear
- 6th Gear
- Thrust Washer
- For 2nd gear assembly
- Inner Race/Needle Bearing
- Needle Bearing
- For 2nd gear assembly
- 2nd Gear Assembly
- Synchronization
- For the 2nd gear assembly / reverse gear assembly
- Installation position: the bevel of the locking collar -arrow- points to the 2nd gear assembly
- Overview. Refer to Overview - Synchronization .
- Press out the synchronizer hub. Refer to Figure.
- Install the synchronizer hub. Refer to Figure.
- Reverse Gear Assembly
- Needle Bearing
- For reverse gear assembly
- Inner Race/Needle Bearing
- Thrust Washer
- For reverse gear assembly
- Bearing Bracket
- With reverse gear intermediate sprocket
- Overview. Refer to OVERVIEW - BEARING BRACKET .
- Removing. Refer to Figure.
- Installing. Refer to Figure.
- Disassembling and Assembling. Refer to BEARING BRACKET, DISASSEMBLING AND ASSEMBLING .
- Thrust Washer
- For 1st Gear Assembly
- Inner Race/Needle Bearing
- Needle Bearing
- For 1st Gear Assembly
- 1st Gear Assembly
- Synchronization
- For 1st Gear Assembly / 3rd Gear Assembly
- Overview. Refer to Overview - Synchronization .
- Press out the synchronizer hub. Refer to Figure.
- Install the synchronizer hub. Refer to Figure.
- 3rd Gear Assembly
- Needle Bearing
- For 3rd gear assembly
- Outer Output Shaft
- With splines for 5th and 7th gears
- Removing and Installing. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to OUTPUT SHAFT, DISASSEMBLING AND ASSEMBLING .
- Bearing Inner Race
- Bearing "F"
- For output shaft roller sleeve
- Removing. Refer to AWD Vehicles .
- Installing. Refer to AWD Vehicles .
- Circlip