A/C Compressor Ribbed Belt, Removing And Installing, 2.9L Engine With Radiator Installed: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.

-- Position the ribbed belt. Refer to OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE .

-- Position the Driveshaft Handle:3145 on the ribbed belt, pivot counter-clockwise and remove the Locking Pin:T10060A .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the counterholder.

-- Check if the ribbed belt is correctly positioned.

-- Start the engine and check the ribbed belt routing.

-- Check the coolant level. Refer to Fig 1.

Fig 1: Coolant Level, Checking after Repair

Courtesy of AUDI OF AMERICA, LLC