Coupling Point On Right A-Pillar, Bottom TARU, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the right lower A-pillar trim panel. Refer to A-PILLAR LOWER TRIM PANEL, REMOVING AND INSTALLING .

-- Disconnect the battery. Refer to Battery A, Disconnecting and Connecting .

-- Release the retainer -5-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the cover -4- -arrow-.

-- Remove the nuts -1-, -2- and -3-.

-- Free up the wires.

-- Open the clip -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Pull the relay -2- out of the mount -1-.

-- Release the retainer -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Tilt the coupling point -3- slightly toward the interior and disengage.

-- Release the clips -arrows-.

Fig 1: Identifying Relay Panel And Connector Station

Courtesy of AUDI OF AMERICA, LLC

-- Push out the relay panel -2- from the bracket -1-.