Garage Door Opener Control Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

If the Garage Door Opener Control Module -J530- is being replaced, then the test plan for replacing the control module must be performed.

-- Perform the "control module, replacing" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the retainers -1-.

-- Remove the Garage Door Opener Control Module -J530- -3- from the mount -2- -arrow-.