Transmission Mount, Removing And Installing, Automatic Transmission
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Transmission Support, Removing with Transmission Mount
-- Remove the tunnel crossmember. Refer to appropriate Service Information .
-- Remove the bolts -arrows- and remove the transmission support -1- with the transmission mount from the transmission.
Transmission Mount, Removing
-- Remove the bolts -1- and remove the stop -2- for the transmission mount.
-- Remove the nut -5- and remove the transmission mount -3- from the transmission support -4-. (The transmission support does not correspond to the version in the vehicle.)
Installing
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
-- Tighten the nut -5- hand-tight.
-- Tighten the bolts -1- and then the nut -5-.
Tightening Specifications
- Refer to appropriate Service Information .