Tire Pressure Monitoring System, Storing Changed Tire Pressure Values
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of injury due to unintended engine start on high-voltage vehicles!
- Pay attention to the high-voltage system warning messages:
- For procedures where the ignition must be switched off, refer to PROCEDURES THAT NEED IGNITION SWITCHED ON .
During each inspection (after check or adjustment of tire pressures) or after a wheel is changed, the Tire Pressure Monitoring System must be initialized.
Requirements:
- Before storing, the driving tire pressures must be correctly adjusted.
Procedure :
-- Turn on the ignition and activate the MMI.
-- Select the CAR function button.
-- Follow the following menu structure under >>Systems<< :
- Service & Checking
- Tire Pressure Monitoring System
- Tire Pressure, Storing
-- Activate the storing of tire pressures using the MMI control knob.