Overview - Bumper Carrier
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- A -
Bumper Carrier, Equipment Version without Trailer Hitch
- 1 -
Bumper Carrier
- Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING, EQUIPMENT VERSION WITHOUT TRAILER HITCH .
- 2 -
Bolt
- Always replace after removing
- Quantity: 3
- Tightening specification and sequence. Refer to Fig 2.
- 3 -
Foam Seal
- 4 -
Nut
- 55 Nm
- 5 -
Foam Seal
- 6 -
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Quantity: 3
- 7 -
Towing eye
- B -
Bumper Carrier, Equipment Version with Trailer Hitch
- 1 -
Socket
- Removing and installing. Refer to Interior Lights, Lamps and Switches .
- Connector assignment. Refer to Interior Lights, Lamps and Switches .
- 2 -
Filler Piece
- Left
- 3 -
Bumper Carrier
- Removing and Installing. Refer to BUMPER CARRIER, REMOVING AND INSTALLING, EQUIPMENT VERSION WITH TRAILER HITCH .
- 4 -
Grommet
- 5 -
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- 6 -
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- 7 -
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- 8 -
Bolt
- Always replace after removing
- Tightening specification and sequence. Refer to Fig 3.
- 9 -
Filler Piece
- Right
- 10 -
Towing Eye
Bumper Carrier without Trailer Hitch - Tightening Specification and Sequence
-- Tighten the bolts and nuts in the order shown.
| Bolts/Nuts | Tightening Specification/Additional Turn |
|---|---|
| -1 to 6- | 50 Nm + 45° |
| -7- | 50 Nm + 45° |
Bumper Carrier with Trailer Hitch - Tightening Specification and Sequence
-- Tighten the bolts in the sequence shown.
| Bolts | Tightening Specification/Additional Turn |
|---|---|
| M10 | 60 Nm + 90° |
| M12 | 70 Nm + 180° |