Molded Foam Part Mount, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the license plate bracket. Refer to LICENSE PLATE HOLDER, REMOVING AND INSTALLING .
-- Remove the bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Free up the wiring harness -5-.
-- Pry out the clips -arrows- at the same time do not damage the tab.
-- Remove the bolts -1 and 3-.
-- Remove the mount -2- and at the same time the tab under the center end panel -4-.