Front Spoiler Upper Section, Removing And Installing, A6 ALLROAD: Installing

Install in the reverse order of removal while noting the following:

• The vehicle and the front spoiler upper section must be room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution :D 009 401 04  and let dry.

-- Fold back the end of the protective film, or attach a pulling aid to the protective film.

-- Position the front spoiler-upper section to the bumper cover side panel.

-- Remove the protective film on the pulling aids from the adhesive tape.

-- Press on the front spoiler upper section using the Roller :T40400  .

• Resting time approximately 30 minutes at room temperature