Connecting Brace, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

Left:

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Release and disconnect the connector for the Driver Front Airbag Crash Sensor -G283-. Refer to COMPONENT LOCATION OVERVIEW - AIRBAG CRASH SENSORS .

-- If equipped, free up the wiring harness -3-.

-- Remove the bolts -1 and 4- and then remove the connecting brace -2-.

Right:

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Release and disconnect the connector on the Passenger Side Front Airbag Crash Sensor -G284-. Refer to COMPONENT LOCATION OVERVIEW - AIRBAG CRASH SENSORS .

-- If equipped, free up the wiring harness -2-.

-- Remove the bolts -1 and 4- and then remove the connecting brace -3-.