Overview - Air Routing And Air Distribution In Passenger Compartment, Front
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The overview shows a LHD vehicle as an example. The component layout is a mirror image for RHD vehicles.
- Air Duct
- Left Front Footwell Vent
- Removing and Installing. Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .
- Expanding Rivet
- Left Instrument Panel Vent
- Removing and Installing. Refer to OVERVIEW - INSTRUMENT PANEL
- Front Heater and A/C Unit
- There are different versions. Refer to the Parts Information.
- Overview. Refer to OVERVIEW - HEATER AND A/C UNIT .
- Air intake, air vents and air routing in the heater and A/C unit. Refer to AIR DUCT IN FRONT HEATER AND A/C UNIT .
- Expanding Rivet
- Left Front Upper Body Vent Temperature Sensor -G385-
- Removing and Installing. Refer to Left Front Upper Body Vent Temperature Sensor -G385-, REMOVING AND INSTALLING .
- Outer Left Air Duct
- There are different versions. Refer to the Parts Information.
- Equipped on some models with Driver Side Ionizer -J1105-. Refer to COMPONENT LOCATION OVERVIEW - AIR IONIZATION for the component location overview.
-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .
-- Remove the Christmas Tree™ fastener and the air distribution housing.
-- Disconnect the connectors and remove the air distribution housing.
- Left Air Duct
- Air Duct
- For the windshield projection control module
- Expanding Rivet
- Quantity: 2
- Air Duct/Defrost Intermediate Piece
-- Removing and installing. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .
-- Remove the expanding rivet and the intermediate piece.
- Expanding Rivet
- Air Duct to Center Instrument Panel Vents
- Removing and Installing. Refer to CENTER INSTRUMENT PANEL VENT AIR DUCT, REMOVING AND INSTALLING .
- Right Air Duct Channel
- Remove the instrument panel crossmember. Refer to INSTRUMENT PANEL CROSSMEMBER, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Outer Right Air Duct
- There are different versions. Refer to the Parts Information.
- Equipment versions with Front Passenger Side Ionizer -J1106-. Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - AIR IONIZATION .
-- Remove the instrument panel. Refer to INSTRUMENT PANEL, REMOVING AND INSTALLING .
-- Remove the expanding rivet and the bolt.
-- Disconnect the connectors and remove the air distribution housing.
- Expanding Rivet
- Right Front Upper Body Vent Temperature Sensor -G386-
- Removing and Installing. Refer to Right Front Upper Body Vent Temperature Sensor -G386-, REMOVING AND INSTALLING .
- Expanding Rivet
- Bolt
- 3 Nm
- Center Instrument Panel Vent
- Removing and Installing. Refer to OVERVIEW - INSTRUMENT PANEL
- Expanding Rivet
- Right Front Footwell Vent