Component Location Overview - Abs/Esp
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The overview shows a LHD vehicle as an example. For RHD vehicles the layout is a mirror image.
- Front Speed Sensor
- Left Front ABS Wheel Speed Sensor -G47-
- Right Front ABS Wheel Speed Sensor -G45-
- Overview. Refer to OVERVIEW - FRONT AXLE SPEED SENSOR .
- Brake Pedal Position Sensor -G100-
- For vehicles with high-voltage system
- Component location in the electric Brake Booster -NX6-
- Overview. Refer to OVERVIEW - BRAKE BOOSTER/BRAKE MASTER CYLINDER, ELECTROMECHANICAL BRAKE BOOSTER .
- Hydraulic Control Unit
- With
- ABS Control Module -J104-
- ABS Hydraulic Unit -N55-
- The control module and the hydraulic unit can be separated
- Overview. Refer to OVERVIEW - CONTROL MODULE AND HYDRAULIC UNIT .
- With
- Vacuum Sensor -G608-
- Overview. Refer to OVERVIEW - VACUUM PUMP, 3.0L TDI ENGINE - NOT FOR USA/CDN MARKET .
- Switch Module in Instrument Panel, Center -EX22-
- With
- ASR/ESP Button -E256-
- Removing and Installing. Refer to SWITCH MODULE IN INSTRUMENT PANEL, CENTER EX22, REMOVING AND INSTALLING
- With
- Parking Brake Button -EX12-
- With
- Electromechanical Parking Brake Indicator Lamp -K213-
- Push Button Illumination Bulb -L76-
- Removing and installing. Refer to PARKING BRAKE BUTTON EX12, REMOVING AND INSTALLING .
- With
- Rear Speed Sensor
- Right Rear ABS Wheel Speed Sensor -G44-
- Left Rear ABS Wheel Speed Sensor -G46-
- Refer to OVERVIEW - REAR AXLE SPEED SENSOR
- Brake Pad Wear Sensor
- Left Front Brake Pad Wear Sensor -G34-
- Right Front Brake Pad Wear Sensor -G35- (installed depending on model and version)
- Refer to OVERVIEW - FRONT BRAKES
- Left Rear Brake Pad Wear Sensor -G36- (installed depending on model and version)
- Right Rear Brake Pad Wear Sensor -G37-
- Refer to OVERVIEW - REAR BRAKES
- In the respective inner brake pad
- Instrument Cluster with Instrument Cluster Control Module -J285-
- With
- Parking Brake Indicator Lamp -K139-
- The indicator lamps cannot be replaced separately
- Replace the instrument cluster if faulty. Refer to OVERVIEW - INSTRUMENT CLUSTER .
- With
- Brake Lamp Switch -F- with Brake Pedal Position Sensor -G100-
- Brake Lamp Switch
- Component location: on the brake master cylinder
- Refer to OVERVIEW - BRAKE BOOSTER/BRAKE MASTER CYLINDER, VACUUM BRAKE BOOSTER
- Refer to BRAKE LAMP SWITCH, REMOVING AND INSTALLING
- After installing, the Brake Pedal Position Sensor - G100- must be recalibrated.
- To do this, go into "Guided Functions, Basic Setting, Brake Pedal Position Sensor G100".