Vacuum Pump, Removing And Installing, 2.9L/3.0L TFSI Engine: Installing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Check the vacuum lines for damage before assembling and replace if necessary.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
-- Position the vacuum pump driver -1- so it engages in the symmetrical groove on the camshaft when positioning -arrows-.
-- Install the vacuum line with the hose clamp -1- connected.
-- Install the air duct pipes. Refer to AIR DUCT PIPE, REMOVING AND INSTALLING .