Brake Pad Wear Indicator Wire, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear wheel. Refer to WHEELS AND TIRES .
-- Disconnect the connector -2- from the brake pad wear indicator contact.
-- Release the connector -1- to the brake pad wear indicator contact from its bracket in direction of -arrow A- while turning it 90° at the same time in direction of -arrow B-.
-- Free up the wire by removing the protective cap -2- from the bleed screw and remove the clips -1 and 5-.
-- Carefully remove the contact -3- for the brake pad wear indicator using pliers while paying attention to the clip -4-. (shown on ceramic brakes)