Brake Caliper, Replacing, Six-Piston Ceramic Brake: Installing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Clip the wire bracket into the new brake caliper.

-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, SIX-PISTON CERAMIC BRAKE .

-- Install the brake hose -3- in the brake caliper and tighten.

Fig 1: Identifying Union Bolt And Brake Hose

Courtesy of AUDI OF AMERICA, LLC

-- Check the spring -2- for damage and replace if necessary.

-- Insert the brake hose into the bracket -arrow- and connect it to the brake line by tightening the union bolt -1-.

Make sure the brake hose is routed correctly.
Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.

-- Remove the Brake Pedal Actuator:V.A.G 1869/2 .

Only bleed the brake system on the wheel which the brake caliper and the brake line was separated. If the brake still feels "soft", completely bleed the brake system.

-- Install the front wheel, while observing the safety precautions for vehicles with ceramic brakes. Refer to WHEELS AND TIRES .

CAUTION:

Faulty brakes increase the risk of an accident.

- Make sure the brakes are working correctly before driving the vehicle for the first time.