Mounting Bracket, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .

-- Disconnect the brake pedal from the brake booster. Refer to BRAKE PEDAL, DISCONNECTING FROM BRAKE BOOSTER .

Vehicle with Vacuum Brake Booster:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

Vehicle with Electromechanical Brake Booster:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows-.

Continuation for All:

-- Remove the steering column from the instrument panel crossmember and set it aside. Refer to appropriate Service Information .

-- Disconnect the connectors -arrows- and free up the wire.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- and nut -2-, then remove the mounting bracket with the brake pedal and accelerator pedal module installed.

-- Remove the brake pedal. Refer to BRAKE PEDAL, REMOVING AND INSTALLING .

-- Remove the accelerator pedal module. Refer to ACCELERATOR PEDAL MODULE -GX2-, REMOVING AND INSTALLING .