Input Shaft Seal, Replacing, Clutch Housing
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
Procedure
- Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
-- With the Puller - Crankshaft/Power Steering Seal:T20143 carefully remove the seal -arrow- from the housing.
-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.
- Pay attention to the installation position.
-- Drive the new seal in all the way using the Thrust Piece:T40300 .
-- Dual Clutch, Installing. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .