Electronic Damping Basic Setting
WARNING: This page is about a different car, the 2024 Audi S6 and 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Select this basic setting for the following operations:
- The threaded connection for a level control system sensor was loosened.
- A level control system sensor was removed and installed.
- A front or rear shock absorber was replaced.
- The Drivetrain Control Module -J775- was removed and installed.
-- After performing the respective procedures, select the "Basic Setting, Complete" program. Refer to DIAGNOSTIC ENTRIES .
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
The following procedures must be performed after a basic setting:
- Adjust the headlamps. Refer to HEADLAMP, ADJUSTING, LED HEADLAMP .
- Driver Assistance Systems Front Camera, Calibrating. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .