Overview - Rear Lid Tail Lamps, Sedan

Fig 1: Exploded View Of Rear LID Tail Lamps, Sedan

Courtesy of AUDI OF AMERICA, LLC

1. Cover
   • For the tail lamp
   • Removing and installing. Refer to REAR LID TAIL LAMP, REMOVING AND INSTALLING, SEDAN .
2. Adjusting Screw
   • To align the tail lamps to the body contours. Refer to REAR LID TAIL LAMP, ALIGNING WITH BODY CONTOUR .
3. Tail Lamp Bulb 2
   • Left Tail Lamp Bulb 2 -M49-
   • Right Tail Lamp Bulb 2 -M50-
   • Bulb, Replacing. Refer to REAR LID TAIL LAMP BULB, REMOVING AND INSTALLING, SEDAN .
4. Bulb Socket
   • Removing and installing. Refer to REAR LID TAIL LAMP BULB, REMOVING AND INSTALLING, SEDAN .
5. Seal
   • Replace if damaged
6. Bulb Socket
   • Removing and installing. Refer to REAR LID TAIL LAMP BULB, REMOVING AND INSTALLING, SEDAN .
7. Rear Fog Lamp Bulb
   • Left Rear Fog Lamp Bulb -L46-
   • Right Rear Fog Lamp Bulb -L47-
   • Bulb, Replacing. Refer to REAR LID TAIL LAMP BULB, REMOVING AND INSTALLING, SEDAN .
8. Nut
   • Quantity: 3
   • Tightening specifications. Refer to Fig 2.
9. Adjusting Screw
   • To align the tail lamps to the body contours. Refer to REAR LID TAIL LAMP, ALIGNING WITH BODY CONTOUR .
10. Tail Lamp
    • Left Tail Lamp 2 -MX5-
    • Right Tail Lamp 2 -MX6-
    • LED version: If an LED is malfunctioning, the tail lamp must be completely replaced
    • Removing and installing. Refer to REAR LID TAIL LAMP, REMOVING AND INSTALLING, SEDAN .
    • Adjusting. Refer to TAIL LAMP, CORRECTING INSTALLATION POSITION .

Tightening Specification and Sequence for the Tail Lamps

Fig 2: Tightening Specification and Sequence for the Tail Lamps

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts for the tail lamps to 4 Nm and in the sequence -1, 2 and 3-.